AV Instructions: ETB 524
From SEPT Knowledge Base
Overview
The images below highlight the locations of the 3 main components of the AV system:
- The pull down projector screen
- Wall mounted AV cabinet
- Equipment inside AV cabinet

The AV cabinet (shown below) has a combination lock on it.
- To unlock the cabinet, set the passcode combination to 5240 and twist the knob clockwise.
- To lock the cabinet, twist the knob counterclockwise while the door is closed and change the passcode combination.


Equipment Usage
Projector Remote
- To turn on the projector, point the remote control (shown below) to the projector and press the power on button. The ID 4 button will light up if input from the power buttons are registered. The projector will take several minutes to load and turn on.
- To turn off the projector, point the remote control to the projector and press the power off button once, and then a second time when prompted by the projector to do so.

Microphones
There are 2 microphones in the AV cabinet for this room.
- Flip the power switch on MIC 1 (shown below) upwards to turn it on. The display screen will light up and display battery percentage.
- Flip the power switch downwards to turn MIC 1 off.

- The power button is the red button on the bottom of MIC 2 (shown below). Press and hold the power button to turn the microphone on. The display screen will display battery percentage once successfully powered.
- Press and hold the power button to turn MIC 2 off.

Extension Cord
There is an power supply in the AV cabinet with an outlet to plug an extension cord into. Ensure that the extension cord is powered on.
- Please do not turn off the power supply.

Connecting to Projector
As there is no computer in this room, an external device will be required to project from.
- Connect the HDMI cable to the device. This will allow screen projection and link the device’s audio to the room’s speakers.
- If using the built-in webcam, connect the webcam cable to the device.

Troubleshooting
No sound
- If there is no sound after connecting the HDMI cable, connect the AUX cable to the device as well. Refer to the image above for connections.
- (closeup photos of the sections and knobs if we remove the DO NOT TURN ANY DIALS sticker, and add "turn volume knob as required" on this list)